Ford Corsar Repair Manual page 380

TROUBLE DIAGNOSES
1
KA24E
1
Electrical Components Inspection (Cont'd)
THROTTLE SENSOR
1. Disconnect throttle sensor harness connector.
2.
Make sure that resistance between terminals
@
and
@
changes when opening throttle valve manually.
If N.G., replace throttle sensor.
Adjustment
If throttle sensor is replaced or removed, it is necessary to
install it in the proper position, by following the procedure as
shown below:
Accelerator pq++conditions
Completely released
Partially released
Completely depressed
1. Install throttle sensor body in throttle chamber. Do not
tighten bolts.
2. Connect throttle sensor and idle switch harness connector.
3. Start engine and warm it up sufficiently.
Perform "THROTTLE SEN. ADJ." in "WORK
SUPPORT" mode.
Resistance
kR
Approximately 1
1 - 9
Approximately 9
Measure output voltage of throttle sensor using
voltmeter.
5.
Adjust by rotating throttle sensor body so that output
voltage is 0.4 to 0.5V.
6. Tighten mounting bolts.
7. Disconnect throttle sensor harness connector for a few
seconds and then reconnect it.
FUEL PUMP
Check continuity between terminals @I and @
.
Continuity should exist.