Ford Corsar Repair Manual page 632

FRONT AXLE
-
Wheel Hub and Knuckle
Installation
Install knuckle with wheel hub.
When installing camber adjusting bolt, use the marks made dur-
ing removal.
Tighten wheel bearing lock nut.
[nl: 235
-
314 Nom
(24
-
32 kg-m, 174
-
231 ft-lb)
Disassembly
CAUTION:
When removing wheel hub or wheel bearing from knuckle,
replace wheel bearing assembly (outer race, inner race and
grease seals) with new parts.
WHEEL HUB
m
Driveout hub with inner race Afrom knuckle with toolasshown.
m
Refer to FRONT AXLE.
WHEEL BEARING
When replacing wheel be&ing, replace wheel bearing
assembly (inner and outer races).
Using suitable puller and half plates E6673 remove bearing inner
race (outside), then remove outer grease seal.
m
Remove inner grease seal from knuckle.
Remove inner and outer snap rings.