Ford Corsar Repair Manual page 523

SAT014C
Terminal cord assembly
Wrapped
SAT02 1 C
TROUBLE-SHOOTING AND DIAGNOSES
/ - K G q
Electrical Components Inspection (Cont'd)
1
INHIBITOR SWITCH
1. Disconnect control cable from manual shaft.
2. Check continuity between terminals
@
and
@
and between
terminals
@
and
0, 0,
@,
0,
@, @
while moving selector
lever through each range.
3. If N.G., adjust inhibitor switch.
4. Check terminal continuity again.
5. If N.G., replace inhibitor switch.
FLUID TEMPERATURE SENSOR
For removal and installation, refer to "ON-VEHICLE SERV-
ICE".
Check resistance between two terminals while changing
temperature as shown as left.
Resistance kS2