Ford Corsar Repair Manual page 563

REPAIR FOR COMPONENT PARTS
p i 6 i q
Governor
A newly developed governor valve assembly has been used to
improve the shift timing.
I t is made of pressed steel instead of aluminum.
Replace the assembly if damaged because it cannot be disas-
sembled and assembled.
Construction
View A
4
Low boost
High secondary spring
Center boost spring
High boost spring
W
Primary weight
Low secondary
weight
Low
overnor valve weight primary
weight
Governor pressure outlet
Line pressure inlet
Governor plunger
View A
SAT683A
The governor plunger and the valve are moved upward by the
return spring force and the line pressure circuit is shut by the
governor valve when driving at low speed.
There are two secondary weights, that is a low secondary
weight and a high secondary weight, on the top of the
assembly and they contact the upper end of the governor
valve.
Both secondary weights have primary weights.
The weights are as follows:
Low secondary weight
+
High secondary weight
<
High
primary weight
<
Low primary weight
Each secondary weight is pushed downward by centrifugal
force when driving
a t
a rather high speed, and governor
pressure exsists.