Ford Corsar Repair Manual page 571

Measuring points
S A T 9 0 0
Clearance
SAT659
SAT808
'
j&
REPAIR FOR COMPONEN+^PARTS
p z i i i q
Oil Pump (Cont'd)
"
INSPECTION
1. Inspect oil pump cover, cam ring, rotor and vanes for
damage and visible wear.
2. Measure clearance between clutch housing and cam ring,
rotor and vanes in at least four places along their circum-
stances. The maximum measured value should be within the
specified range.
Be sure to remove friction ring and vane ring when
measuring clearance.
Standard clearance:
0.010
-
0.024 mm (0.0004
-
0.0009 in)
Wear limit:
0.034 mm (0.0013 in)
If the clearance is out of above specification, replace oil
pump as an assembly.
3. Measure clearance between seal ring and ring groove.
Standard clearance:
'
0.10
-
0.25 mm (0.0039
-
0.0098 in)
Wear limit:
0.25 mm (0.0098 in)
ASSEMBLY
1. Install cam ring, 0-ring and friction ring.
2. Install return spring and spring retainer.