Ford Corsar Repair Manual page 153

ENGINE COOLING SYSTEM
Radiator
REMOVAL AND INSTALLATION
m
3.2
-
4.2 (0.33
-
0.43, 2.4
-
3.1)
Radiator upper hose
Reservoir tank
Radiator rubber mounting
Radiator lower hose
fan
Radiator shroud
m
3.2
-
4.2 (0.33
-
0.43, 2.4
-
3.1)
m
: N m (kg-m, ft-lb)
Radiator Minor Repair Procedure
(Using Agent Part No. 2 141 1 -J7025)
Minor radiator repairs are defined as damage to tubes
in the form of holes no greater than approximately
1 mm.
1. Remove radiator.
2. If necessary, carefully cut away or bend fins to
expose affected area. Do not cut away what is not
necessary and do not remove more than 25mm
(total) finning from the radiator.
3. Dry affected tube and area with an air drier.
4. Lightly surface damaged area with suitable
scraper and wipe clean with petrol.
5. Mix contents of bottle well and apply repair agent
to affected area with a suitable clean, dry ap-
plicator (cut down wooden stirrer).
6.
Apply repair agent sparingly.
7. Repair agent must be allowed to dry in ambient
conditions for a minimum of
3
hours before
re-fitting the radiator in vehicle.
Do not use heat to promote drying.
8 . Refit radiator and refill cooling system (refer Sec-
tion MA).