Ford Corsar Repair Manual page 628

CHECK AND ADJUSTMENT
Front Wheel Alignment (Cont'd)
2. Measure toe-in.
Measure distance "A" and "B" at the same height as hub
center.
Toe-in (Unladen):
3. Adjust toe-in by varying the length of steering tie-rods.
(1) Loosen lock nuts.
(2) Adjust toe-in by turning tie-rod tubes forwards or backwards.
A
-
B
mm (in)
26
degree
Length "L" should be approximately equal L/H to R/H sides.
Maximum variance: 2 m m
(3) Tighten lock nuts, then torque them.
Refer to ST section.
1
-
3 (0.04
-
0.12)
6'
-
18'
FRONT
WHEEL
TURNING ANGLE
1. Set wheels in straight-ahead position and then move vehicle
forward until front wheels rest on turning radius gauge
properly.
2. Rotate steering wheel all the way right and left; measure
turning angle.
FA- 7
Values
34"-38"
27"-3 1'
22'20'
20"
Wheel turning angle
Full turns
Toe-out turn (at 20')
Inside wheel
Outside wheel
Inside wheel
Outside wheel