ENGINE OVERHAUL -Assembly-
I'ziq
Cylinder No.
S E M 5 9 0 A
E M 1 5 6
PI.1.d
I
Front
S E M 6 1 7
FLYWHEEL RUNOUT
Runout (Total indicator reading):
Less than 0.1 5 mm (0.0059 in)
PISTON
a.
Numbers stamped on the connecting rod and cap correspond
to each cylinder. Care should be taken to avoid a wrong com-
bination including bearing.
b. When pressing piston pin in connecting rod, apply engine
oil to pin and small end of connecting rod.
c. After assembling, ascertain that piston swings smoothly.
1. Install piston rings.
CRANKSHAFT
1.
Set main bearings in the proper position on cylinder block.
If either crankshaft, cylinder block or main bearing i s reused
again, it i s necessary to measure main bearing clearance.
Upper bearings (Cylinder block side) have oil groove.