Ford Corsar Repair Manual page 426

REPAIR FOR COMPONENT PARTS
@
SMT64OA
Baulk ring to
gear cleara
SMT140
Mainshaft and Gears (Cont'd)
INSPECTION
Gear and shaft
Check shaft for cracks, wear or bending.
Check gears for excessive wear, chips or cracks.
Synchronizer
Check spline portion of coupling sleeves, hubs and gears
for wear or cracks.
Check baulk rings for cracks or deformation.
Check insert springs for deformation.
Measure clearance between baulk ring and gear.
Clearance between baulk ring and gear:
Standard
1.0
-
1.35 mm (0.0394
-
0.0531 in)
Wear limit
0.7 mm (0.028 in)
Bearing
Make sure bearings roll freely and are free from noise,
cracks, pitting or wear.
When replacing tapered roller bearing, replace outer and
inner race as a set.