Ford Corsar Repair Manual page 433

ADJUSTMENT
lnput Shaft End Play and Differential Side
Bearing Preload
If any of the following parts are replaced, adjust input shaft end
play.
a
lnput shaft
a
lnput shaft bearing
a
Clutch housing
a
Transmission case
If any of the following parts are replaced, adjust differential side
bearing preload.
a
Differential case
a
Differential side bearing
a
Clutch housing
a
Transmission case
1. Remove differential side beacing outer race (transmission case
side) and shim(s) using E7 128 puller.
Remove input shaft case welch plug.
2. Reinstall differential side bearing outer race without shim(s).
3. Install input shaft and final drive assembly on clutch housing.
4. Install transmission case without input shaft bearing shim(s).
Then tighten it to the spe'cified torque.
5. Using the following procedures, measure clearance between
bearings and transmission case.
m
Differential side
a. Attach dial indicator. If clamp diameter of dial indicator is
too small or too large, attach dial indicator using a magnetic
stand.