Ford Corsar Repair Manual page 118

CYLINDER HEAD -Installation-
1
Head
bolt
Washer
Flat face downward. S E M 6 5 4 A
Tightening order
This bolt is
the longest.
S E M 2 8 5 B
1. Install cylinder head with new gasket.
Be sure to install washers between bolts and head.
Do not rotate crankshaft and camshaft separately, because valves
will hit piston heads.
2. Apply oil to the thread portion and seat surface of bolts and
tighten cylinder head bolts.
Tightening procedure.
1st
Tighten a l l bolts to 29 N.m (3.0 kg-m, 22 ft-lb).
2nd
Tighten a l l bolts to 78 N-m (8.0 kg-m, 58 ft-lb).
3rd Loosen all bolts completely.
4th
Tighten a l l bolts to 29 N.m (3.0 kg-m, 22 ft-lb).
5th Using an angle wrench, turn bolt
@ 83
t o 88 degrees
and the other bolts 75 t o 80 degrees clockwise.
3. Install camshaft, locating plate, rear cover and camshaft pulley
(whilst holding pulley with E7 18 1 A
: Camshaft pulley:
78
-
88 N.m (8.0
-
9.0 kg-m, 58
- 65 ft-lb)
Locating plate bolt:
78
-
88 N-m (8.0
-
9.0 kg-m, 58
-
65 ft-lb)
4. Confirm that No. 1 cylinder is set
a t T.D.C. on i t s compres-
sion stroke
as
follows:
(1) Check crankshaft key near to the top.
S E M 8 3 8 A
(2) Check camshaft pulley aligning mark
a t
the top.