Ford Corsar Repair Manual page 594

REPAIR FOR COMPONENT PARTS
p z q
Planetary Carrier
INSPECTION
Check clearance between pinion washer and planetary
carrier with a feeler gauge.
Standard clearance:
Front carrier
0.15
-
0.70
mm
(0.0059
-
0.0276
in)
Rear
carrier
0.20
-
0.70 mm (0.0079
-
0.0276 in)
Replace if the clearance exceeds 0.80 mm (0.0315 in).
Check planetary gear sets and bearings for damaged or
worn gears.
Bearing Retainer and Output Shaft
INSPECTION
Measure clearance between seal ring and ring groove.
Standard clearance:
0.10
-
0.25 mm (0.0039
-
0.0098 in)
Wear limit:
0.25 mm (0.0098 in)
Converter Housing and Transmission Case
BEARING OUTER RACE
Reduction pinion gear front bearing outer race
Remove and refit as shown.
Reduction pinion gear front bearing.
Remove using E1 673MT puller in conjunction with E 1673C 15
plates.
Refit using E7001.