Ford Corsar Repair Manual page 755

@
0
Cowl top seal and cowl top grille
INTERIOR AND EXTERIOR
Exterior (Cont'd)
@
Front bumper sight shield
@
Windshield upper molding
Apply sealant to top portion of
molding.
I
Refer to "Body Front End".
Cut off lower portion
of new molding.
Method 1
Cut off top portion of molding
and clean glass and panel
surfaces.
Finish well t o give i t a
good appearance.
Method
2
1 . 'cut off sealant a t glass end.
@ @ Hood molding and hood front seal
2.
Clean the side on which panel was mounted.
3. Set molding fastener and apply sealant to body
I
panel, and apply primer to molding and body.(
sealant
-I
Apply sealant.
~ p p ~ y primer.
I
4. Install molding by aligning the molding mark
located on center with vehicle center.
Be sure to install tightly so that there is no gap
around the corner.
@
Windshield lower molding
It is mounted with screws.