Ford Corsar Repair Manual page 152

ENGINE COOLING SYSTEM
Water Pump (Cont'd)
CAUTION :
When removing water pump assembly, be careful not to
get coolant on timing belt.
Water pump cannot be disassembled and should be
replaced as a unit.
To avoid damaging timing cover, make sure there is
adequate clearance between it and the hose clamp.
a
After installing water pump, connect hose and clamp
securely, then check for leaks using radiator cap tester.
When refilling cooling system, refer Section MA.
INSPECTION
1. Check for badly rusted or corroded vanes and body as-
sembly.
2. Check for rough operation due to excessive end play.
Thermostat
INSPECTION
1. Check valve seating condition at ordinary room tempera-
tures. lt should seat tightly.
2. Check valve opening temperature and maximum valve lift.
-
Maximum valve lift 8/90 (0.311194)
3. Then check if valve is S°C (g°F) below valve opening
temperature.
After installation, run engine for a few minutes, and check
for leaks.
Be careful not to spill coolant over engine compartment.
Use a rag to absorb coolant.
Electric Cooling Fan Control System
Radiator fan and condenser fan are both controlled by E.C.C.S. con-
trol unit.
For details, refer to ES section.