Ford Corsar Repair Manual page 610

ASSEMBLY
(Output gear side)
SAT878
29.
Adjust output shaft and idler gear bearing preload as follows:
a. Remove output gear and idler gear bearing outer races and
shims. (The races will interchange, so be sure to keep each
race with its correct bearing.)
b. Measure dimension H and K between mating surface of side
cover and fitting surface of bearing.
c. Put bearing outer races on output gear and idler gear.
d. Place Tool on transmission case and place a straightedge on
Tool.
e. Measure dimension I and L from straightedge to top of
bearing outer races.
Output gear side:
Clearance J = H
+
I
-
60 mm (2.36 in)
Idler gear side:
Clearance M = K
+
L
-
60 mm (2.36 in)
f. Select shim(s) of appropriate thickness, using S.D.S. as a
guide.
& F
*\
Drift
SAT880