Ford Corsar Repair Manual page 867

WIPER AND WASHER
Installation
1. Prior to wiper arm installation, turn on wiper switch to
operate wiper motor and then turn it "OFF" (Auto Stop).
2. Lift the blade up and then set it down onto glass surface to
set the blade center to clearance "C" or "D" immediately
before tightening nut.
3. Eject washer fluid. Turn on wiper switch to operate wiper
motor and then turn it "OFF".
4. Ensure that wiper blades stop within clearance "C" or "D".
Clearance "C": 20
-
35 mm (0.79
-
1.38 in)
Clearance "D": 25
-
35 mm (0.98
-
1.38 in)
Tighten windshield wiper arm nuts to specified torque.
Front wiper:
[nJ:
17
-
23 Nom (1.7
-
2.3 kg-m, 12
-
17 ft-lb)
Rear wiper:
[nJ: 13
-
18 Nom (1.3
-
1.8 kg-m, 9
-
13 ft-lb)
-
Clearance "C"
,--?I
-
i t
i / A
1, '
t
f 9
Unit: mm (in)
Lower windshield molding
A l l the d~ameters of these circles are
less than 80 (3.15).
S E L 2 1 7 K
Before reinstalling wiper arm, clean up the pivot area as
illustrated. This will reduce possibility of wiper arm
looseness.