Ford Corsar Repair Manual page 657

CHECK AND ADJUSTMENT
Rear Wheel Bearing
Check tightening torque of wheel bearing lock nut.
(nl: 186
-
255 Nom
(19
-
26 kg-m, 137
-
188 ft-lb)
Check that wheel bearings operate smoothly.
Check axial end play.
Axial end play:
0.05 mm (0.0020 in) or less
If there is any axial end play or wheel bearing does not turn
smoothly, replace wheel bearing assembly.
Refer to REAR AXLE-Wheel Hub
Rear Wheel Alignment
PRELIMINARY INSPECTION
Make following checks. Adjust, repair or replace if necessary.
Check tires for wear and for improper inflation.
Check rear wheel bearings for looseness.
Check wheel runout.
1
Steel
Check that rear strut (shock absorber) works properly.
Check rear axle and rear suspension parts for looseness.
a
Check vehicle posture (Unladen).
"Unladen":
Fuel tank, radiator and engine oil full. Spare tire, jack, hand
tools and mats in designated positions.
CAMBER
Camber is preset at factory and cannot be adjusted.
Camber:
-0'48'
+
0'45'
If the camber is not within specification, inspect and replace
any damaged or worn rear suspension parts.