Ford Corsar Repair Manual page 88

CYLINDER BLOCK
1 ~ ~ 2 4 ~ 1
-
SEM062A
ber
SEM262C
EM156
3
Inspection (Cont'd)
REPLACEMENT OF CONNECTING ROD BUSHING
(Small end)
1. Drive in small end bushing until it is flush with end surface
of rod.
Be sure to align the oil holes.
2. After driving in small end bushing, ream the bushing so that
clearance between small end bushing and piston pin is
specified valve.
Clearance between small end bushing and piston pin:
0.005
-
0.017 mm (0.0002
-
0.0007 in)
FLYWHEELIDRIVE PLATE RUNOUT
Runout (Total indicator reading):
Flywheel (MIT model)
Less than 0.1 mm (0.004 in)
Drive plate (AIT model)
Less than 0.1 mm (0.004 in)
Assembly
PISTON
1. Install new snap ring on one side of piston pin hole.
2. Heat piston to 60 to 70°C (140 to 158OF) and assemble
piston, piston pin, connecting rod and new snap ring.
Align the direction of piston and connecting rod.
Numbers stamped on connecting rod and cap correspond
to each cylinder.
After assembly, make sure connecting rod swings
smoothly.