Ford Corsar Repair Manual page 548

REPAIR FOR COMPONENT PARTS
I
RL4F02A
I
otor support ring
SATOOBA
B : Big diameter
SATOOOA
Oil Pump (Cont'd)
2. Assemble rotor, vanes, friction ring, rotor support ring and
vane rings.
Pay attention to direction of rotor.
3. Install oil pump cover.
Tighten down cover evenly in a criss-cross type pattern.
4. Rotate pump when it has been assembled to ensure that all
parts have been correctly assembled.
5. Install seal rings.
Refer to figure at left for proper locations of two different
types of seal rings.
These seal rings can be cut or deformed if they are improperly
seated in their grooves when drum is installed. Clean ring
grooves carefully and fill with petroleum jelly. Then install rings
making sure they fit into the grooves as tightly as possible.
AT- 1 04