Ford Corsar Repair Manual page 557

REPAIR FOR COMPONENT PARTS
[ X i E q
Snap ring
Retainer plate
7
Clearance
SAT396A
High Clutch (Cont'd)
6. Measure clearance between retaining plate and snap ring.
Always measure the existing minimum clearance, since snap
ring is a wave type.
Specified clearance between retaining plate and snap
ring:
Standard
1.8
-
2.2 mm (0.071
-
0.087 in)
Allowable limit
2.8 mm (0.110 in)
Available retaining plate: Refer to
S.D.S.
7. Check high clutch operation using compressed air
Low Clutch
For the number of clutch sheets (drive plate and Low clutch hub
driven plate), refer to the below cross-section.
Low clutch piston
Low dished plate
Low dished plate
S A T 7 0 2 6