Ford Corsar Repair Manual page 37

ENGINE MAINTENANCE
1
~ ~ 2 4 ~
Changing Fuel Filter (Cont'd)
5. Loosen fuel hose clamps.
6. Replace fuel filter.
8
Use a high-pressure type fuel filter. Do not use a synthetic
resinous fuel filter.
When tightening fuel hose clamps, refer to "Checking Fuel
Lines".
Changing Air Cleaner Filter
The viscous paper type filter does not need cleaning between
renewals.
Changing Engine Oil and Oil Filter
1. Warm up engine, then stop it, and check for oil leakage from
engine components.
2. Remove oil filler cap and drain oil.
WARNING
Be careful not to burn yourself, as the engine oil may be hot.
3.
Clean and install oil pan drain plug with washer.
: Drain plug
29
-
39 N-m
(3.0 -4.0 kg-m, 22- 29 ft-lb)
1
4. Remove oil filter.
5. Wipe oil filter mounting surface.
6.
Smear a little engine oil on rubber gasket of oil filter.
7. Install oil filter.
When installing oil filter, screw
it
in until a slight resistance is
felt, then tighten additionally more than 2 1 3 turn.
8. Refill engine with recommended engine oil.
With filter change 3.6 litres.