Ford Corsar Repair Manual page 606

ASSEMBLY
Total end play
a.
Place removed bearing race onto high clutch drum.
b. Measure dimension A from transmission case surface to
installed bearing race.
H ~ g h clutch and reverse
clutch assembly
bri g
r p +
SAT864
H ~ g h clutch and reverse
clutch assembly
P I
SAT866
-
Stratghtedge
~ 7 1 9 2
T ,
I
\
c. Install needle bearing on top of oil pump cover.
d. Set tools on converter housing and place a straightedge on
tools.
e. Measure dimension B from straightedge to installed needle
bearing.
Total end play
=
A
+
B
-
99.6 mm (3.921 in)
Specified total end play:
0.25
-
0.55 mm (0.0098
-
0.0217 in)
Total end play can be adjusted with oil pump bearing races.
Available oil pump bearing races: Refer to S.D.S.
\
I
Clutch pack end play
a. Measure dimension C from transmission case surface to
reverse clutch drum.
b. Install the removed thrust washer on oil pump cover.
7
Thrust
c. Set up Tool in a manner similar to measuring total end play,
and measure dimension D between staightedge and thrust
washer.
Clutch pack end play
= C
+
D
-
99.6 mm (3.921 in)
Specified clutch pack end play:
0.4
-
0.8 mm (0.016
-
0.031 in)
Clutch pack end play can be adjusted with clutch pack thrust
washers.
Available clutch pack thrust washers: Refer to S.D.S.
D
washer