Ford Corsar Repair Manual page 411

ON-VEHICLE SERVICE
Replacing Oil Seal
DIFFERENTIAL OIL SEAL
1. Drain gear oil from transaxle.
2. Remove drive shafts
-
Refer to section FA.
3. Remove differential oil seal.
4. Install differential oil
seal.
Apply multi-purpose grease to seal lip of oil seal before
installing.
5. Install drive shafts
-
Refer to section FA.
STRIKING ROD OIL SEAL
.
1. Remove transaxle control rod from yoke.
2. Remove retaining pin of yoke.
a
Be careful not to damage boot.
3. Remove striking rod oil seal.
4. Install striking rod oil seal.
Apply multi-purpose grease to seal lip of oil seal before
installing.