Ford Corsar Repair Manual page 556

REPAIR FOR COMPONENT PARTS
p G q
Thickness
v
Fac~ng
Core plate
SAT845A
S A T 8 1 9
High Clutch (Cont'd)
INSPECTION
Check clutch drive plate facing for weak or damage.
Standard drive plate thickness:
2.0 mm (0.079 in)
Wear limit:
1.8 mm (0.071 in)
If not within wear limit, replace.
Check for wear on snap ring, weak or broken coil springs,
and warped spring retainer.
ASSEMBLY
1. Lubricate clutch drum bushing, and install inner seal and
piston seal. Be careful not to stretch seals during installation.
Never assemble clutch dry; always lubricate its compo-
nents thoroughly.
Pay attention to direction of piston seal.
2. Assemble piston, being careful not to allow seal to kink or
become damaged during .installation. After installing, turn
piston by hand to ensure that there is no binding.
3. Install clutch springs using E7 179 spring compressor.
4. Reinstall snap ring. Be sure snap ring is properly seated.
5. Install driven plates, drive plates, and secure with snap ring.