Ford Corsar Repair Manual page 167

PRECAUTIONS
p % q
Do not operate the fuel pump Always use
a
12-volt battery as When installing tranceiver equip-
when the fuel lines are empty.
power source. ment or a mobile phone, be sure
Do not attempt to disconnect the
to observe the following notes
battery cables while the engine as it may adversely affect the
is running. electronic control systems
depending on its installation
location.
Do not disconnect the E.C.C.S.
harness connectors before the
battery ground cable has been
disconnected.
Securely connect the E.C.C.S.
harness connector.
A poor connection can cause an
extremely high (surge) voltage to
develop in coil and condenser,
Do not depress the accelerator
thus resulting in damage to ICs.
pedal when starting.
Do not disassemble the E.C.M.
Keep the E.C.C.S. harness a t least immediately after do (Electronic Control Module)
10 cm (3.9 in) away from adjacent
rev U P the engine unnecessarily.
harnesses, to prevent an E.C.C.S.
DO
"Of
rev U P the engine just prior
system malfunction due to re-
to shutdown.
ceiving an external noise, degraded
operation of ICs, etc.
Keep E.C.C.S. parts and harnesses
dry.
Before removing parts, turn off
the ignition switch and disconnect
the battery ground cable.
1) Keep the antenna a s far as possible
away from the electronic control
unit.
2)
Keep the antenna feeder line
more than
20
cm (7.9 in) away
from the harness of electronic
controls.
Do not let them run parallel for
a long distance.
3) Adjust the antenna and feeder
line so that the standing-wave
ratio can be kept smaller.
4) Be sure to ground the radio to
vehicle body.