Ford Corsar Repair Manual page 633

FRONT AXLE
-
Wheel Hub and Knuckle
Disassembly (Cont'd)
Press out bearing outer race using tools as shown.
Inspection
WHEEL HUB AND KNUCKLE
Check wheel hub and knuckle for cracks.
Check snap ring for wear or cracks. Replace if necessary.
WHEEL BEARING & GREASE SEAL
Removal of wheel bearing and grease seal necessitates replace-
ment with new parts.
Assembly
1. Install snap ring into groove of knuckle.
2. Press bearing outer race into knuckle until
it contacts the sharp
ring using tool as shown.
3. Pack each bearing cone with wheel bearing grease.