Bank Angle Sensor - Honda SH300 2006 Manual

FUEL SYSTEM (PGM-FI)

BANK ANGLE SENSOR

REMOVAL
Turn the ignition switch "OFF".
Remove the rear fender A (page 3-7).
Disconnect the bank angle sensor 3P connector.
Remove the two screws and bank angle sensor.
INSTALLATION
Install the bank angle sensor with its "UP" mark fac-
ing up.
Install and tighten the two screws to the specified
torque.
TORQUE: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)
Connect the bank angle sensor 3P connector.
Install the following:
– Rear fender A (page 3-7)
– Body cover (page 3-6)
– Grub rail (page 3-5)
– Luggage box (page 3-5)
6-72
BANK ANGLE
SENSOR
SCREWS
BANK ANGLE
SENSOR
SCREWS
3P CONNECTOR
3P CONNECTOR