Bank Angle Sensor - Honda INTERCEPTOR 2002 Service Manual

FUEL SYSTEM (Programmed Fuel Injection)
BANK ANGLE SENSOR
INSPECTION
Support the motorcycle level surface.
Remove the upper cowl (page 2-12).
Turn the ignition switch ON and measure the volt-
age between the following terminals of the bank
angle sensor connector with the connector con-
nected.
b
TERMINAL
White/black (+) - Green (-) Battery voltage
Red/white (+) -Green (- ) 0- 1 V
'--- - - - --
Turn the ignition switch OFF.
Do not d1sconnect
Remove the screws/nuts and bank angle sensor.
the bank angle sen-
sor connector dur-
mg mspect1on.
5-82
Place the bank angle sensor horizontal as shown,
and ignition switch ON.
The bank angle sensor is normal if the engine stop
relay clicks and power supply is closed.
Incline the bank angle sensor approximately 60
degrees to the left or right w ith the ignition switch
ON.
The bank angle sensor is normal if the engine stop
relay clicks and power supply is open.
If you repeat this test, first turn the ignit ion switch
OFF, then turn the ignition switch ON.
REMOVAL/INSTALLATION
Disconnect the bank angle sensor 3P (Green) con-
nector.
Remove the two screws, nuts and bank angle sen-
sor.
60° BANK ANGLE POSITION
0
NORMAL
'"""'m ""''
p
POSITION
(app roximately)