Rep 8.8.1 External H/R Heater Rod - Xerox DocuColor 12/DCCS50 Service Manual

REP 8.8.1 External H/R Heater Rod

Parts List on PL 8.8
Removal
Turn power off and disconnect the power plug.
Since the Fuser is very hot, wait until the Fuser becomes sufficiently cold.
Do not touch the glass surface of the Heater Rod. If the glass surface is accidentally touched,
wipe it with a dry cloth.
1. Open the Front Door.
2. Remove the Fuser Unit (REP 8.1.1).
3. Remove the following parts:
a. Front Cover (PL 8.1)
b. Top Cover (PL 8.2)
4. Disconnect the connectors (Figure
1. Disconnect the connectors (3).
2. Release the clamps (2) and remove the wire.
3. Remove the wire from the saddle edge.
Reissue
DocuColor 12/DCCS50
WARNING
CAUTION
CAUTION
1).
Figure 1 Disconnect the Connectors (Front of Fuser)
5. Disconnect the connectors (Figure
1. Disconnect the connectors (2).
2. Release the clamp and remove the wire.
3. Remove the wire from the saddle edge.
1/05
4-133
2).
Repairs and Adjustments
REP 8.8.1