Figure 2 Hook the Bracket Hooks
5.
Remove the Rotary Latch Lever
(Figure
1. Remove the connectors (2).
2. Remove the screws (2).
3. Remove the Rotary Latch Lever.
4. If the Solenoid Assy is to be replaced, remove the screws (2).
5. If the Solenoid Assy is to be replaced, remove the Gear.
Repairs and Adjustments
REP 6.1.3
3).
Figure 3 Remove the Rotary Latch Lever
Installation
1.
Perform
ADJ 6.6.1
Rotary Development Housing Position and install the locating pin to
position the Black Development Housing against the Drum.
2.
If the Solenoid Assy was replaced, install the new Solenoid on the Rotary Latch lever
bracket, and reinstall the Gear. Ensure that the flag on the plunger fully blocks the sensor
when the plunger is pushed in.
3.
Lock the Rotary Latch Lever
1. Turn the gear and push in the plunger.
1/05
4-80
manuals4you.com
manuals4you.com
(Figure
4).
DocuColor 12/DCCS50
Reissue