Rep 8.4.1 Web Motor/Ext-Hr Retract Motor - Xerox DocuColor 12/DCCS50 Service Manual

Figure 3 Install the Heat Roll Stripper Finger
1. Reinstall the parts in the reverse order of disassembly.
2. Perform the Standard Fuser Break-In Procedure
Repairs and Adjustments
REP 8.3.5, REP 8.4.1
(GP 1 Fuser Break-In Procedure).
manuals4you.com manuals4you.com

REP 8.4.1 Web Motor/EXT-HR Retract Motor

Parts List on PL 8.4
Removal
Turn power off and disconnect the power plug.
Since the Fuser is very hot, wait until the Fuser becomes sufficiently cold.
1. Open the Front Door.
2. Remove the Fuser Unit (REP
3. Remove the Front Cover (PL
4. Remove the Web Assembly (Figure
1. Press the Latch Release Buttons (2).
2. Remove the Web Assembly.
Figure 1 Remove the Web Assembly
5. Remove the bracket (Figure 2).
1. Release the clamp and remove the wire.
2. Remove the wire from the edge saddle.
3. Disconnect the connector.
1/05
4-128
WARNING
CAUTION
8.1.1).
8.1).
1).
DocuColor 12/DCCS50
Reissue