Rep 7.5.1 Ibt Belt - Xerox DocuColor 12/DCCS50 Service Manual

REP 7.5.1 IBT Belt

Parts List on PL 7.5
Removal
NOTE: After replacing the IBT Belt, clear the HFSI. Enter the
Screen:
1. DC 135 (NVM 009-805)
2. DC135 (NVM 009-806)
Turn power off and disconnect the power plug.
NOTE: When removing the IBT, make sure that the IBT Belt does not touch any other part.
NOTE: Carefully place the removed IBT on a flat surface (covered with a sheet of paper).
1. Open the Front Door.
2. Remove the IBT (REP 7.1.1).
3. Remove the IBT Cleaner (REP 7.1.2).
4. Move the stoppers (2) in the direction of the arrow and lock the roll
rear.
1. Move the stoppers (2), front and rear.
Figure 1 Move the Stoppers
Repairs and Adjustments
REP 7.5.1
dC135 HFSI Counter List
WARNING
(Figure
5. Raise the IBT.
6. Remove the Inlet Plate
1. Remove the screw.
2. Remove the Inlet Plate.
Diag.
1), front and
7. Move the roll and loosen the tension
1. Remove the screws (2).
2. Remove the bracket.
3. Remove the screws (2).
4. Hold the bracket and move the roll.
5. Hook the bracket hole to the boss.
1/05
4-102
manuals4you.com manuals4you.com
(Figure 2).
Figure 2 Remove the Inlet Plate
(Figure 3).
Reissue
DocuColor 12/DCCS50