Table of Contents
Advertisement
9-667 VH/VM Out Of Range RAP
The selected LD value was out of range.
Initial Actions
•
Refer to BSD 9.1 and BSD 9.15 for the following procedure.
•
Clean the ESV Sensor.
•
Check that
P/J141
on the ESV Sensor, and
connected.
Procedure
Perform the following in the order listed.
•
Go to the
IQ 38 Charge Corotron HVPS RAP
proper operation.
•
Ensure that the Charge Corotron Wire and Grid are in good condition.
•
Go to
Flag 6
and
Flag 7
on BSD 9.1. Check the wires for an open circuit or a short circuit.
If the wires are good, replace the ESV Sensor
the IOT Drive PWB
(PL
9.2).
•
If the fault was declared during the VH portion of dC933, replace the Xerographic Module
(Drum CRU)
(Machine
Consumables, Section 6).
If the fault was declared during the VM portion of dC933, replace the ROS Assembly
4.1).
Status Indicator RAPs
9-667 VH/VM Out Of Range RAP
P/J422A
on the IOT Drive PWB are firmly
and check the Charge Corotron HVPS for
(PL
5.1). If the problem continues, replace
(PL
manuals4you.com
manuals4you.com
1/05
2-134
Reissue
DocuColor 12/DCCS50
Advertisement
Table of Contents
Troubleshooting
