Table of Contents
Advertisement
10-160 Duplex In Sensor On Jam RAP
Duplex In Sensor Paper Static Jam.
Initial Actions
Refer to BSD 10.10 and 10.12 for the following procedure.
Check for the following:
•
Clean the Duplex In Sensor
(PL
2.24).
•
Ensure that connectors
P/J412A
and
and the Duplex In Sensor, and there are no obvious crimped or broken wires.
•
Ensure the Inverter is closed. Switch the power Off then On.
Procedure
Enter dC330 010-130 Duplex In Sensor. Press Start. The display indicates L.
Y
N
Go to
Flag 3
and
Flag 4
on BSD 10.10 and check the harness for a open circuit. If the har-
ness is good, replace the Duplex In Sensor
If the fault code is present and can not be cleared, replace the IOT Drive PWB
fault code is not present and is occurring intermittently, go to
and check the harness for an intermittent open circuit. If the harness is OK, replace the Duplex
In Sensor
(PL
2.24). If the problem continues, replace the IOT Drive PWB
Reissue
DocuColor 12/DCCS50
P/J150
are seated correctly on the IOT Drive PWB
(PL
2.24).
(PL
Flag 3
and
Flag 4
on BSD 10.10
(PL
9.2).
10-162 Duplex Path 1 Sensor On Jam RAP
Duplex Path Sensor Paper Static Jam.
Initial Actions
Refer to BSD 10.10 and 10.12 for the following procedure.
Check for the following:
•
Clean the Duplex Path Sensor
•
Ensure that connectors
and the Duplex Path Sensor, and there are no obvious crimped or broken wires.
•
Ensure the Drawer is closed. Switch the power Off then On.
Procedure
Enter dC330 010-132 Duplex Path Sensor. Press Start. The display indicates L.
Y
N
Go to
Flag 7
and
Flag 8
ness is good, replace the Duplex Path Sensor
9.2). If the
If the fault code is present and can not be cleared, replace the IOT Drive PWB
fault code is not present and is occurring intermittently, go to
and check the harness for an intermittent open circuit. If the harness is OK, replace the Duplex
In Sensor
(PL
2.21). If the problem continues, replace the IOT Drive PWB
1/05
10-160 Duplex In Sensor On Jam RAP, 10-162 Du-
2-151
(PL
2.21).
P/J420
and
P/J154
are seated correctly on the IOT Drive PWB
on BSD 10.10 and check the harness for a open circuit. If the har-
(PL
2.21).
Flag 7
and
(PL
9.2). If the
Flag 8
on BSD 10.10
(PL
9.2).
Status Indicator RAPs
Advertisement
Table of Contents
Troubleshooting
