Rep 2.7.1 Tray 2-4 Take Away Drive; Rep 2.7.2 Tray 2/3/4 Feed T/A Clutch; Removing The Tray 2-4 Take Away Drive; Disconnecting The Connector - Xerox DocuColor 12/DCCS50 Service Manual

REP 2.7.1 Tray 2-4 Take Away Drive

Parts List on PL 2.7B
Removal
Turn power off and disconnect the power plug.
1. Remove the following parts:
a. IOT LVPS (REP 9.3.2).
b. LVPS bracket (PL 9.3 Item 4)
2. Remove the Tray 2-4 Take Away Drive
1. Disconnect the connector.
2. Remove the screws (4).
3. Remove the Tray 2-4 Take Away Drive.
Figure 1 Removing the Tray 2-4 Take Away Drive
Installation
1. Reinstall the parts in the reverse order of disassembly.
Repairs and Adjustments
REP 2.7.1, REP 2.7.2
WARNING
(Figure 1).

REP 2.7.2 Tray 2/3/4 Feed T/A Clutch

Parts List on PL 2.7A
Removal
NOTE: This page describes how to remove the Tray 2 Feed T/A Clutch.
Turn power off and disconnect the power plug.
1. Remove the Tray 2-4 Take Away Drive
2. Disconnect the connector
1. Disconnect the connector.
2. Remove the wire from the saddle edge.
Figure 1 Disconnecting the connector
3. Remove the Tray 2 Feed T/A Clutch
1. Remove the E-clip.
2. Remove the gear.
3. Remove the bearing.
4. Remove the shaft. (Push the release button on the clutch.)
5. Remove the Tray 2 Feed T/A Clutch.
1/05
4-22
manuals4you.com manuals4you.com
WARNING
(REP 2.7.1).
(Figure 1).
(Figure 2).
DocuColor 12/DCCS50
Reissue