Rep 2.16.1 Pre Regi. Sensor; Rep 2.16.2 Pre Regi. Roll - Xerox DocuColor 12/DCCS50 Service Manual

REP 2.16.1 Pre Regi. Sensor

Parts List on PL 2.16
Removal
Turn power off and disconnect the power plug.
1. Open the Front Door.
2. Remove the Regi. Unit (REP 2.14.1).
3. Remove the Pre-Regi. Sensor with the bracket
1. Remove the screw.
2. Remove the bracket.
3. Disconnect the connector.
4. Remove the wire from the edge saddle.
Figure 1 Removing the Pre-Regi. Sensor
Installation
1. Reinstall the parts in the reverse order of disassembly.
Repairs and Adjustments
REP 2.16.1, REP 2.16.2
WARNING
(Figure 1).

REP 2.16.2 Pre Regi. Roll

Parts List on PL 2.16
Removal
Turn power off and disconnect the power plug.
1. Open the Front Door.
2. Remove the Regi. Unit (REP
3. Lower the chute (Figure
1. Remove the screw.
2. Remove the coupling.
3. Remove the screws (2).
4. Lower the chute.
4. Remove the Pre-Regi. Roll
1. Remove the E-clip.
2. Move the bearing in the direction of the arrow.
3. Remove the Pre-Regi. Roll.
1/05
4-38
manuals4you.com manuals4you.com
WARNING
2.14.1).
1).
Figure 1 Lowering the Chute
(Figure 2).
Reissue
DocuColor 12/DCCS50