Table of Contents
Advertisement
NOTE: Values that are out of range will cause the Error Tab to turn "Red".
NOTE: While a value is highlighted, you can write an NVM value in it.
Writing NVM
1.
To write a new value, first enter a new value in the "New" column
2.
Select Write NVM.
a.
If the input value is valid (within the range), the system writes the new NVM value in
the NVM code in the machine.
b.
If the input value is invalid, the system displays the following message in the informa-
tion screen, "The given NVM value is out of range. NVM was not changed".
c.
If the NVM cannot be changed (Write protected NVM), the system displays the fol-
lowing message, "! The specified NVM is read only".
d.
When the system writes the new value in the specified NVM code, the value is
updated in the "New Box" and reduces the count in the "Changed Tab".
NOTE: When a value is written in the vertical "Changed Tab", the tab will turn green.
The number in "parenthesis"() will count the number of pending NVM values. Click-
ing the tab once will show a list of all the changed values. If a new value is input but
not yet written, the changed value is captured in the "Changed" Vertical Left Tab List.
Reissue
DocuColor 12/DCCS50
dC131 UI/Tools (700)
Table 1 UI/Tools (700)
Chain-
Link
Name
700-091 Customer Paper Size FS 200
700-092 Customer Paper Size SS 300
700-093 Equal Magnification -
Fine Adjustment (FS)
700-094 Equal Magnification -
Fine Adjustment (FS)
700-096 PA Entry Key - Coin Kit
700-097 ACS Platen Start Check
700-098 Tray 5 Paper Size
700-099 UI Post Flag
700-100 Lighter - Darker Default
700-101 Hue Control Default
700-102 Chroma Control Default
700-103 Sharpness Default
700-104 Color Balance Default (Y
High)
700-105 Color Balance Default (Y
Middle)
1/05
dC131 NVM Read/Write, dC131 UI/Tools (700)
6-27
Default
Range
Description
0-297
Free Paper Size Registration (FS)
0-432
Free Paper Size Registration (SS)
20
0-40
98-102%. In 0.1% increments.
The equation is (98+(set value x
0.1)). Default of 20 = 100%
From IOT S/W 6.00.2, can be set in
tools mode
0
0-40
98-102%. In 0.1% increments.
The equation is (98+(set value x
0.1)). Default of 20 = 100%
0
0-1
To enable or disable PA Entry Key
Display (for Coin Kit)
0= OFF
1= ON
0
0-1
0= Check on
1= Check off
1
0-5
0= Heavyweight Paper/Tracking
film.
1= Heavyweight Paper, duplex (MN
default.
2= Labels.
3= Label/tracing paper.
4= Duplex middle weight.
5= Label/Duplex heavy weight
paper.
1
0-1
UI Flag - enables features such as
Posters, Cover Sheets, HCF
0= Poster Flag Off
1= Poster Flag On
3
0-7
Copy Density Setup (Prevents
copying see-thru image)
3
0-5
1= 20
2= 10
3= 0
4= 10
5= 20
0
0-5
0
0-5
0
0-7
Copy Density Setup (Prevents
copying see thru image)
0
0-7
Copy Density Setup (Prevents
copying see-thru image)
General Procedures
Advertisement
Table of Contents
Troubleshooting
