Rep 8.7.1 Oil Pump - Xerox DocuColor 12/DCCS50 Service Manual

REP 8.7.1 Oil Pump

Parts List on PL 8.7
Removal
Turn power off and disconnect the power plug.
Since the Fuser is very hot, wait until the Fuser becomes sufficiently cold.
1. Open the Front Door.
2. Remove the Fuser Unit (REP 8.1.1).
3. Remove the Front Cover (PL 8.1).
4. Move the clamp in the direction of the arrow
1. Disconnect the connector.
2. Move the clamps (2) in the direction of the arrow.
Figure 1 Move the Clamps
5. Remove the Oil Pump (Figure 2).
NOTE: After removing the Oil Pump, drain the oil remaining in the tube into the tank.
1. Remove the screw.
2. Remove the Oil Pump.
Reissue
DocuColor 12/DCCS50
WARNING
CAUTION
(Figure 1).
Figure 2 Remove the Oil Pump
Installation
1. Reinstall the parts in the reverse order of disassembly.
2. Perform the Full Fuser Break-In Procedure
1/05
4-131
(GP 1 Fuser Break-In Procedure).
Repairs and Adjustments
REP 8.7.1