Table of Contents
Advertisement
A
B
Press the Start button. The voltage at P/J414B-12 goes to less than +2.0 VDC.
Y
N
Replace the IOT Drive PWB
(PL
Replace the Tray 1 Takeaway Feed Clutch
Check/replace the following components until the problem is resolved. Replace any compo-
nents that are worn, broken, binding, or slipping.
•
Pinch Rolls and Springs
(PL
2.8)
•
Check for burrs on the Baffle
(PL
2.8).
Reissue
DocuColor 12/DCCS50
9.2).
(PL
1.5).
8-148 Tray 2 Takeaway Sensor On Jam RAP
The Takeaway Sensor did not actuate within 220 - 320 msec after the Tray 2 feed started.
Initial Actions
•
Refer to BSD 8.2, BSD 8.6, and BSD 8.10 for the following procedure.
•
Check for any obstructions in the paper path.
•
Open the Lower Left Door
(PL
2.8).
Procedure
Cheat the L/H Cover Interlock Switch. Enter dC330 008-150 Take Away Sensor. Press Start.
Block the Takeaway Sensor with a sheet of paper. The display changes from H to L.
Y
N
The display indicates a constant H.
Y
N
Go to
Flag 1
on BSD 8.6 and check the harness for a short circuit. If the harness is
good, replace the Takeaway Sensor
Connect the meter from P/J420A-B5 on the IOT Drive PWB to machine frame. Block the
Takeaway Sensor with a sheet of paper. The voltage at
VDC when the sensor is unblocked, to less than +1.0 VDC when the sensor is
blocked.
Y
N
There is +5 VDC between P/J420A-B6 and P/J420A-B4 on the IOT Drive PWB.
Y
N
Go to
Flag 2
on BSD 8.6 and check the harness for a short circuit. If the har-
ness is good, replace the IOT Drive PWB
Go to
Flag 1
and
Flag 2
on BSD 8.6 and check the harness for an open circuit. If the
harness is OK, replace the Takeaway Sensor
replace the IOT Drive PWB
Replace the IOT Drive PWB
(PL
Enter dC330 008-025 Take Away Motor. Press Start. The Takeaway Motor energizes.
Y
N
Go to the
Takeaway Motor
RAP.
Enter dC330 008-014 Tray 2 Take Away Feed Clutch. Press Start and Stop several times.
The Tray 2 Takeaway Feed Clutch energizes.
Y
N
Press the Stop button. There is +24 VDC at P/J802B-14 on the Tray PWB.
Y
N
Replace the Tray PWB
(PL
There is +24 VDC at P/J802B-13 on the Tray PWB.
Y
N
Go to
Flag 5
on BSD 8.2 and check the harness for an open circuit. If the harness is
good, replace the Tray 2 Takeaway Feed Clutch
A
B
1/05
8-147 Tray 1 Takeaway Sensor On Jam RAP, 8-148
2-93
(PL
2.8).
P/J420A-B5 goes from +5
(PL
9.2).
(PL
2.8). If the problem continues,
(PL
9.2).
9.2).
9.3).
(PL
2.7A).
Status Indicator RAPs
Advertisement
Table of Contents
Troubleshooting
