Removing The Auger Sensor; Rep 1.6.2 Fuser Drive - Xerox DocuColor 12/DCCS50 Service Manual

REP 1.6.2 Fuser Drive

Parts List on PL 1.6
Removal
Turn power off and disconnect the power plug.
1. Remove the following covers:
1. IOT Rear Cover (PL 11.3 Item
2. Tray Module Rear Cover (PL 11.3 Item
3. Filter Unit Cover (PL 11.2 Item
4. Pull out Tray 1.
5. Remove the Auger Sensor and the 2nd BTR HVPS
1. Disconnect the connector.
2. Remove the screw.
3. Remove the sensor.
4. Disconnect the connector.
5. Pull out the connector.
6. Remove the screws (3)
7. Remove the 2nd BTR HVPS.
Reissue
DocuColor 12/DCCS50
WARNING
7)
11)
4)
(Figure 1).
Figure 1 Removing the Auger Sensor
6. Remove the duct (Figure 2).
1. Remove the screws (2).
2. Release the hook and remove the duct.
1/05
4-11
Repairs and Adjustments
REP 1.6.2