Table of Contents
Advertisement
GP 7 Verifying Tools Mode Password
Entering, exiting and changing the Tools Mode Password.
Procedure
Entering Tool Mode
NOTE: You can use the default password (11111) to enter the Tools mode the first time.
1.
Press the Administration button on the Control Panel.
2.
Select the Tools button on the Touch Screen.
3.
Use the keypad to key-in the password (default is 11111).
Exit the Tool Mode
1.
Select the Close button to exit any Tools Mode function without saving.
2.
Select Close to return to the Basic Copy tab.
Changing the Password
1.
Select Change Tools Access Number button on the Tools screen.
2.
Key-in a New Number in the New Number field.
3.
Key-in the same number in Confirm New Number in the Confirm New Number field.
4.
Press the Enter button.
5.
Select the Close button to return to System Administration Item.
Reissue
DocuColor 12/DCCS50
GP 8 IDFE Power OFF/Power ON (PO/PO) Procedure
Description
This procedure is used when a full PO/PO is required for the Integrated Digital Front End
(IDFE).
Procedure
If any of the following steps are not correctly followed, the IDFE will not shut down properly,
and the PO/PO process must be repeated.
NOTE: The IDFE will take approximately three to five minutes to load its software after per-
forming the following steps:
Perform the following:
1.
Switch OFF the Main Switch for the Printer.
When power to the IOT is switched-off, the IDFE Hard Disk Drive goes into a software shut-
down. Damage to the Hard Disk Drive could occur if the IDFE is not allowed to complete the
software shutdown process.
2.
Wait for 30 seconds.
3.
Switch ON the Main Switch for the Printer.
NOTE: The configuration report may take 2 or 3 minutes to print.
1/05
GP 7 Verifying Tools Mode Password, GP 8 IDFE
6-11
CAUTION
CAUTION
General Procedures
Advertisement
Table of Contents
Troubleshooting
