Rep 7.1.1 Ibt - Xerox DocuColor 12/DCCS50 Service Manual

REP 7.1.1 IBT

Parts List on PL 7.1
Removal
Turn power off and disconnect the power plug.
NOTE: When removing the IBT, do not expose the belt to direct sunlight or strong light.
NOTE: When removing the IBT, make sure that the IBT belt does not touch any other part.
NOTE: Carefully place the removed IBT on a flat surface (covered with a sheet of paper).
1. Open the Front Door.
2. Remove the Drum Unit (REP 5.3.1).
3. Remove the Trickle Toner Bottle (PL
4. Lower the lever and pull out the Drawer Assembly.
5. Pull the Drawer Assembly out to the work position
1. Push in the stoppers on both sides.
2. Pull out the Drawer Assembly.
Figure 1 Pull out the drawer
6. Pull out the IBT (Figure 2).
Reissue
DocuColor 12/DCCS50
WARNING
6.5).
(Figure 1).
1. Rotate the lever in the direction of the arrow.
2. Remove the screws (2).
3. Pull out the IBT.
Figure 2 Pull out the IBT
7. Remove the IBT Inner Cover (Figure
1. Remove the screw.
2. Remove the lever.
3. Remove the screws (2).
4. Remove the IBT Inner Cover.
1/05
4-99
3).
Repairs and Adjustments
REP 7.1.1