Table of Contents
Advertisement
dC919 Color Balance Setup (IIT installed machine only)
Purpose
Takes a 4C copy in the Photo Mode and visually checks the Color Balance and then sets the
KYMC Color Balance NVM.
NOTE:
1.
Run this function only when requested by the customer for a Color Adjustment after the
Automatic Gray-Scale Correction has been performed (Tool mode).
2.
Before running this function the dC918 High Light Setup must have been performed prop-
erly.
NOTE: For details on dC919 Color Balance Setup, see Adjustments Section 4:
Color Balance Setup (dC919).
General Procedures
dC919 Color Balance Setup (IIT installed machine
dC920 Developer Unit Check
Purpose
Rotates the Rotary Developer and sets it at the desired position.
Procedure
1.
Enter the Service Diagnostics Mode. Refer to
using the
PWS.
2.
Select Diagnostics on the "Service Entry Screen."
3.
Select System Test in the "Fault Diagnostics Screen".
4.
Select Developer Unit Check (dc920).
ADJ 9.1.8
5.
Select the Developer Unit to move. Select Start.
6.
After checking, move the Developer Unit to the Home Position.
1/05
6-126
manuals4you.com
manuals4you.com
Entering the Service Diagnostic Mode
Reissue
DocuColor 12/DCCS50
Advertisement
Table of Contents
Troubleshooting
