Xerox DocuColor 12/DCCS50 Service Manual page 414

Figure 1 Remove the Upper Cover
4. Turn the Development Housing upside down. Empty the Developer
NOTE: Be careful that the gear is not contaminated by Developer. If contaminated, clean
the gear and make sure that the gear is moving smoothly.
1. Turn the Development Housing in the direction of the arrow.
2. Pour out the Developer.
3. Rotate the Magnet Roll Gear in the direction of the arrow. Pour out the remaining
Developer.
Repairs and Adjustments
REP 6.6.2
(Figure 2).
5. Add the Developer
1. Rotate the Magnet Roll Gear in the direction of the arrow, move the Developer
pack right and left, while adding the Developer.
1/05
4-90
manuals4you.com manuals4you.com
Figure 2 Empty the Developer
(Figure 3).
Reissue
DocuColor 12/DCCS50