Table of Contents
Advertisement
Change Tag Introduction
Important modifications to the copier are identified by a tag number which is recorded on a tag
matrix label attached to the inside of the Front Fuser Cover, or inside the Front Door. This sec-
tion describes all of the tags associated with the copier, as well as multinational applicability,
classification codes, and permanent or temporary modification information.
Classification Codes
A tag number may be required to identify differences between parts that cannot be inter-
changed, or differences in diagnostic, repair, installation, or adjustment procedures.
A tag number may also be required to identify the presence of optional hardware, special non-
volatile memory programming, or whether mandatory modifications have been installed. Each
tag number is given a classification code to identify the type of change that the tag has made.
The classification codes and their descriptions are listed in the table below.
Classification Code
Description
M
Mandatory tag.
N
Tag not installed in the field.
O
Optional tag.
R
Repair Tag.
Reissue
DocuColor 12/DCCS50
Table 1
Processor (P) Tags
Processor Tags
TAG:
P1
CLASS:
N
USE:
ALL
MFG SERIAL NUMBERS:
NAME:
IBT Cleaner Assy.
PURPOSE:
KIT NUMBER:
N/A
REFERENCE:
PL 7.1
TAG:
P2
CLASS:
N
USE:
ALL
MFG SERIAL NUMBERS:
NAME:
Rotary PWB/Plate Assy.
PURPOSE:
Countermeasure for Rotary PWB short circuit problem
KIT NUMBER:
N/A
REFERENCE:
PL 6.1
TAG:
P3
CLASS:
N
USE:
ALL
MFG SERIAL NUMBERS:
NAME:
Aligner Baffle Assy.
PURPOSE:
Duplex Aligner performance improvement
KIT NUMBER:
N/A
REFERENCE:
PL 2.18
1/05
Change Tag Introduction, Processor (P) Tags
6-159
FU2: 040199 FU0: 025021
FU3: 310512043x FU1: 310512691x
FU2: 040199 FU0: 025021
FU3: 310512153x FU1: 310512691x
FU2: 040321 FU0: 025022
FU3: 310512332x FU1: 310512707x
General Procedures
Advertisement
Table of Contents
Troubleshooting
