Table of Contents
Advertisement
ADJ 6.1.1 Rotary Home Position Sensor
Parts List on
PL 6.1
Purpose
This procedure sets the correct NVM values for the Rotary Home Position Sensor.
Adjustment
1.
Perform
ADJ 6.6.1
to set the Rotary Assembly to the Cyan position.
Ensure that the Locating Pin is removed before attempting to run the machine.
2.
Without moving the Rotary Assembly, remove the locating pin and return it to its storage
position.
NOTE: After 776-064 is executed, the value is reset to 0 automatically. There is no need to
reset the NVM value.
3.
Enter
dC131 NVM Read/Write
and change the value in NVM location 776-064 Home
Sensor Adjustment Mode to 1.
4.
Enter
dC330 Component
Control. Execute 009-034 (Dispense Motor C).
While the housing moves from the Cyan position to the Home position, the machine auto-
matically measures and corrects the moving pulses.
Reissue
DocuColor 12/DCCS50
CAUTION
ADJ 6.6.1 Rotary Development Housing Position
Parts List on
PL 6.6
Purpose
To properly position the Rotary Development Housings when performing various set ups.
Adjustment
Turn power off and disconnect the power plug.
1.
Open the Front Door.
2.
Remove the following parts:
a.
Toner Trickle Bottle
(PL
6.5)
b.
Right Upper Cover
(PL
11.2)
Ensure that the Locating Pin is removed and returned to its storage position before attempting
to run the machine.
3.
Remove the Locating Pin
(Figure
1. Loosen the screw.
2. Remove the pin.
Figure 1 Remove the Locating Pin
1/05
4-193
WARNING
CAUTION
1).
Repairs and Adjustments
ADJ 6.1.1, ADJ 6.6.1
Advertisement
Table of Contents
Troubleshooting
