Brocade Communications Systems WFT-2D User Manual page 866

20
Configuring encryption storage targets
5. Select the encryption engine (blade or switch) to configure, then click Next.
FIGURE 370
814
The dialog box contains the following information:
•
Encryption engine: The name of the encryption engine. The list of engines depends on the
scope being viewed:
-
If an encryption group was selected, the list includes all engines in the group.
-
If a switch was selected, the list includes all encryption engines for the switch.
-
If a single encryption engine was selected, the list contains only that engine.
•
Fabric Name: The name of the fabric to which the selected encryption engine (blade or
switch) is configured.
•
Engine Media Type: The media type of the encryption engine. Options are: Tape and Disk.
The Select Target dialog box displays. (Refer to
and target nodes in the same fabric as the encryption engine. The Targets in Fabric table does
not show targets that are already configured in an encryption group.
Select Target dialog box
The dialog box contains the following information:
•
Target Port WWN: The world wide name of the target port in the same fabric as the
encryption engine.
•
Target Port Name: The name of the target port in the same fabric as the encryption engine.
•
Target Node WWN: The world wide name of the target node in the same fabric as the
encryption engine.
•
Target Node Name: The name of the target device.
•
Targets list: Options are: Tape and Disk.
NOTE
The Targets list does not show targets that are already configured in the encryption group.
Figure 370.) The dialog box lists all target ports
Brocade Network Advisor SAN User Manual
53-1003154-01