Brocade Communications Systems WFT-2D User Manual page 1161

3. To add a new policy, perform the following steps.
4. Select a policy type from the Policy Type list.
5. Select a measure from the Measure list.
6. Enter a percentage for the upper boundary in the High Boundary field.
7.
8. (Fabric OS only) Enter a percentage for the buffer in the Buffer Size field.
Brocade Network Advisor SAN User Manual
53-1003154-01
FIGURE 486
Edit Threshold Policy dialog box
a. Click Add.
The New Threshold Policy dialog box displays as shown in
FIGURE 487
New Threshold Policy dialog box
b. Enter a name for the policy (100 characters maximum) in the Name field.
You can only define policies for E_Port and F_Port, and FL_Ports.
You can only define policies for the Tx % Utilization and Rx % Utilization measures. You cannot
add the same measure more than once. If you try to add another threshold with the same
measure, the new values overwrite the older threshold values in the Selected Thresholds list.
When the counter value exceeds high boundary, an event is raised.
(Fabric OS only) Enter a percentage for the lower boundary in the Low Boundary field.
When the counter value goes below the low boundary, an event is raised.
Thresholds and event notification
Figure 487 on page 1109.
28
1109