Table of Contents
Advertisement
24
Editing thresholds
3. Select the threshold you want to change and click Edit.
4. Complete
5. Click OK on the Edit Invalid CRCs Threshold dialog box.
6. Click OK on the Port Fencing dialog box.
Editing an Invalid Words threshold
NOTE
This threshold is only available for Fabric OS devices.
NOTE
This feature requires a Trial or Licensed version.
Use to block a port when the Invalid Word Threshold violation type meets the Fabric OS switch
threshold.
To edit an Invalid Words threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
2. Select Invalid Words (Fabric OS only) from the Violation Type list.
3. Select the threshold you want to change and click Edit.
4. Complete
5. Click OK on the Edit Invalid Words Threshold dialog box.
6. Click OK on the Port Fencing dialog box.
1010
The Edit Invalid CRCs Threshold dialog box displays.
step 4
through
step 7
If the threshold has already been assigned to ports, an "Are you sure you want to make the
requested changes to this threshold on "X" ports?" message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 1007.
The Port Fencing dialog box displays.
The Edit Invalid Words Threshold dialog box displays.
step 4
through
step 7
If the threshold has already been assigned to ports, an "Are you sure you want to make the
requested changes to this threshold on "X" ports?" message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 1007.
in
"Adding an Invalid CRCs threshold"
in
"Adding an Invalid Words threshold"
Brocade Network Advisor SAN User Manual
on page 1001.
"Assigning thresholds"
on
on page 1002.
"Assigning thresholds"
on
53-1003154-01
Advertisement
Chapters
Table of Contents
Troubleshooting
