Key Manager (Eskm/Skm) - Brocade Communications Systems WFT-2D User Manual

20
Creating a new encryption group
Configuring key vault settings for HP Enterprise Secure Key Manager
(ESKM/SKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 764.
Figure 331
FIGURE 331
1. Enter the IP address or host name for the primary key vault.
2. Enter the name of the file that holds the primary key vault's CA key certificate, or browse to the
3. Enter the password you established for the Brocade user group.
4. If you are using a backup key vault, enter the IP address or host name, and the name of the file
5. Click Next.
780
shows the key vault selection dialog box for ESKM/SKM.
Select Key Vault dialog box for ESKM/SKM
desired location.
holding the backup key vault's public key certificate in the fields provided. The same user
name and password used for the primary key vault are automatically applied to the backup
key vault.
The Specify Certificate Signing Request File Name dialog box displays. (Refer to
"Creating a new encryption group"
Figure
Brocade Network Advisor SAN User Manual
53-1003154-01
332.)